Serving Loomis, Penryn & Rocklin — Placer County (916) 313-2587

Staircase Porcelain Tile in Penryn

Polished cream marble-look porcelain tile covering staircase treads and risers

This Penryn custom home had a concrete stair structure that needed tile on both the treads and risers. The material chosen was a cream marble-look polished porcelain — the same tile used on the adjacent main floor, so the staircase reads as a continuous surface from the entry through to the upper landing. Matching the stair tile to the floor tile required careful lot selection to ensure the veining and tone were consistent across both areas.

Stair tread installations require a bullnose or returned edge at the nosing — the forward edge of each tread that overhangs the riser below. We used a matching porcelain bullnose piece rather than a metal edge profile, which gives the stair a cleaner, more integrated look. Each tread was set with full mortar coverage and allowed to cure before the next course was installed, since stair tile is subject to significant point-load stress from foot traffic.

ServiceTile Installation
AreaPenryn, CA
MaterialsCream marble-look polished porcelain with matching bullnose nosing
ScopeResidential — staircase treads and risers
TimelineMulti-day install

What we did

1

Cleaned concrete stair substrate and confirmed all treads were level and consistent in rise height.

2

Set risers first, then tread tiles with bullnose nosing pieces, working from the bottom stair up.

3

Allowed each tread to cure before moving to the next to prevent disturbing the bond under foot traffic.

4

Grouted with cream-toned unsanded grout at tight joints; applied silicone at tread-to-riser transitions.

Stair tile in a Penryn home? Contact us to discuss the project.

Thank you — we received your request. We'll get back to you within 1 business day.