Serving Loomis, Penryn & Rocklin — Placer County (916) 313-2587

Bathroom Tile Installation

Waterproofed correctly. Set precisely. Built to handle daily moisture without compromise.

Modern bathroom with gray marble-look floor tile and black freestanding soaking tub Walk-in shower fully tiled in Calacatta marble-look porcelain with mosaic accents

The waterproofing layer is the job

A bathroom tile installation is only as good as what is behind the tile. The visible surface — the grout lines, the pattern, the finish — matters, but it is the waterproofing membrane underneath that determines whether the installation holds up over years of daily moisture exposure.

We use sheet-applied or liquid-applied waterproofing membranes in all wet areas: shower floors, shower walls to a minimum height of six inches above the curb, tub surrounds, and any niche or bench that will see regular water contact. The membrane is bonded to the substrate and extended up the wall before tile is set. Corners and changes of plane get fabric-reinforced seams. This is not an optional step — it is the job.

For shower floors, we pre-slope the mortar bed toward the drain at a minimum of 1/4 inch per foot, then apply the membrane over the slope. Tile is set on top with the slope maintained through the setting bed. A properly sloped shower floor drains completely after each use and does not hold standing water that promotes mold growth.

Bathroom surfaces we handle

Shower surrounds

Wall tile from floor to ceiling, or to a defined height. Niches, benches, and curbs tiled to match or contrast. Waterproofing under every inch of the wet zone.

Tub decks and surrounds

The tile that wraps a built-in tub is a moisture-exposed surface that needs proper substrate prep and sealed grout joints to stay sound over time.

Bathroom floors

Small-format mosaic tile for wet-room floors (more grout lines means more grip), large-format porcelain for dry zones, and transitions between the two handled cleanly.

Vanity wall tile

The wall behind the vanity — whether a full-height accent or a backsplash band — is a dry-area application that still benefits from careful layout and consistent joint lines.

Available across Placer County

Bathroom tile installation is available in Loomis, Penryn, and Rocklin. Older bathrooms in Loomis and Penryn frequently have original tile over a mortar bed — we assess whether the existing bed is sound before deciding whether to tile over or remove and start fresh. Rocklin projects tend to be full master bath renovations where the scope includes both the shower and the floor in a single coordinated install.

Thank you — we received your request. We'll get back to you within 1 business day.